What should I pay attention to when installing PE electrofusion tee?

As an indispensable component of pipeline connection, the installation process of PE electric fusion tee fittings is crucial and directly affects the stability and safety of the entire pipeline system.

Before installing PE electric fusion tee fittings, the pipeline system must be carefully inspected and thoroughly cleaned to ensure that the inside of the pipeline is clean and free of debris to avoid affecting the connection quality. At the same time, the design drawings and specifications of the pipeline system must be reviewed to ensure that the appropriate PE electric fusion tee fittings are selected for installation.

In terms of tool preparation, a dedicated electric fusion welding machine and corresponding tools are required to install PE electric fusion tee fittings. Before installation, be sure to check the status of the electric fusion welding machine and tools to ensure the normal operation of the equipment. At the same time, other necessary installation tools and auxiliary materials must be prepared to ensure the smooth completion of the installation work.

When performing electric fusion welding, the welding temperature must be strictly controlled. Too high a temperature will cause excessive melting of the weld, affecting the quality of the connection; while too low a temperature will cause the pipe and fittings to not be completely melted, and water leakage is likely to occur. Therefore, during the welding process, the welding temperature must be reasonably controlled according to the material and specifications of the pipe and fittings.

After installation, a pressure test must be performed to ensure the quality of the connection. Through the pressure test, check whether there is water leakage or seepage in the pipeline system to ensure the safe operation of the pipeline system. During the pressure test, be sure to pay attention to safety to avoid accidents caused by excessive pressure.

When installing PE electric fusion tee pipe fittings, safety protection measures must be taken. Operators must wear necessary protective equipment, such as safety helmets, gloves, goggles, etc. to ensure safe operation. At the same time, relevant operating procedures must be observed and strictly followed to avoid accidents.

When installing multiple PE electric fusion tee pipe fittings, pay attention to the welding sequence. It is usually recommended to weld the straight pipe fittings first, then the branch pipe fittings, and finally the tee pipe fittings. This ensures the quality and stability of the connection and avoids loose connections.

When installing PE electric fusion tee pipe fittings, pay attention to environmental conditions. Avoid installation in humid, dusty, high or low temperature environments to avoid affecting the welding quality. When installing in harsh environments, appropriate protective measures should be taken to ensure safe construction.